The TURNOGIVE - Details drawings

! All drawings measures are in millimeters !

The base, made from plywood 9mm.

The arm. Plywood 6mm. You can make additionnal holes to adapt the effective radius of the arc forming the ogive.

The two holders of the rod sustaining the styrofoam block
The rear holder come lower than the base, so you can use the shoulder to align the holder.

Horizontal pieces used to fix the motor. Two identical.

This is the piece where you fix the motor. Adapt the holes to the motor you found. This is only an example

The rod motor box rear face. The front face is identical, without the holes for the motor bolds

The rod motor box top. Bottom is identical